Teach you how to use a binding machine

This article is mainly about the key knowledge points of using binding machines explained by the technical personnel of the binding machine company for your reference:

Firstly, everyone is well aware that during the binding process of the binding machine, the presser foot handwheel is turned clockwise to raise the presser foot, and the binding material is placed under the presser foot. The presser foot handwheel is released from the selected position and automatically pressed tightly. Then, the presser foot handwheel is turned counterclockwise to about 180 ° to lock, and then the needle handle is turned counterclockwise to allow the needle to pass through the material. When the penetration is in place, the lead arm will automatically hang the thread in the needle hook slot. At this time, lift the handle upwards. When the needle exits, the binding thread will follow through the binding material and release the presser foot handwheel in a clockwise direction to complete one stitch binding. Repeat the above procedure and the binding task can be completed immediately.

There are also many user manuals for binding machines, but everyone should know that there are many models of binding machines, including manual, automatic, semi-automatic, and fully automatic binding machines. Although there are many models, the working principles are similar. On general binding machines, there is a ruler that can be used as a reference to adjust the left and right positions. There is a single board at the back that can adjust the front and rear edge distance, which is generally around 2.5CM. Manual machines can adjust the distance by turning the knob at the back of the machine, while automatic machines can adjust the distance by adjusting the two knobs on the side. Once the position is aligned, holes can be punched.

After drilling, the riveted pipe will generally automatically cut and fall into the connecting groove. Simply put the cut rivet tube into the hole, translate it to the left rivet head, insert the centering shaft into the rivet tube, and then press down the handle. Hold it tightly for only 2-3 seconds. The manual binding machine centering spindle must have no gap with the silver knob on it.